Full Length Expansion Board - HP ProLiant DL385p Maintenance And Service Manual

WARNING: To reduce the risk of personal injury, electric shock, or damage to the equipment,
remove the power cord to remove power from the server. The front panel Power On/Standby
button does not completely shut off system power. Portions of the power supply and some
internal circuitry remain active until AC power is removed.
To remove the component:
Power down the server (on page 25).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Extend ("Extend the server from the
3.
on page 27) the server from the rack.
Remove the access panel
4.
Disconnect any external cables that are connected to the expansion board.
5.
Disconnect any internal cables that are connected to the expansion board.
6.
Remove the PCIe riser cage
7.
LED" on page 87).
Remove the expansion board.
8.
To replace the component, reverse the removal procedure.

Full length expansion board

CAUTION: To prevent damage to the server or expansion boards, power down the server
and remove all AC power cords before removing or installing the PCIe riser cage.
To remove the component:
Power down the server (on page 25).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
rack" on page 26) or remove
("Access panel" on page 30).
("Remove the primary PCIe riser
("Remove the server from the
cage" on page 33, "PCIe riser cage
Removal and replacement procedures 53
rack"