If a full-length expansion board is installed in slot 4, release the full-length expansion board retainer,
5.
and then remove the PCIe riser cage.
To install the component, reverse the removal procedure.
PCIe riser board
To remove the component:
Power down the server (on page 25).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Extend
("Extend the server from the
3.
on page 27) the server from the rack.
Remove the access panel
4.
If any full-length expansion boards are installed, release the full-length expansion board retainer (on
5.
page 28).
Remove the PCIe riser cage
6.
LED" on page 87).
Remove any expansion boards from the PCIe riser cage
7.
rack" on page 26) or remove
("Access
panel" on page 30).
("Remove the primary PCIe riser
("Remove the server from the
cage" on page 33,
("Expansion
boards" on page 52).
Removal and replacement procedures 35
rack"
"PCIe riser cage