Item
Description
Power supply 1
3
LED
NIC activity LED
4
NIC link LED
5
Non-hot-plug PCIe riser board slot definitions
Primary
Slot - form
factor
1 - FL/FH
2 - HL/FH
3 - HL/FH
Notes:
•
"Primary" denotes the riser cage is installed in the primary riser connector.
•
"Secondary" denotes the riser cage is installed in the secondary riser connector.
•
Installing the riser cages listed in the table above in either the primary or secondary riser connectors
determines the form factor of the PCI cards supported by those riser cages.
•
FL/FH denotes full-length, full-height. HL/FH denotes half-length, full-height. LP denotes low profile.
•
The riser cages support a maximum power of 150 W with a Hewlett Packard Enterprise power cable.
This cable must be used for PCIe card wattages greater than 75 W.
Status
Off = System is off or power supply has failed.
Solid green = Normal
Off = No network activity
Solid green = Link to network
Flashing green = Network activity
Off = No network link
Green = Network link
PCIe 2 riser slot
description
PCIe2 x16 (8,4,1)
PCIe2 x8 (8,4,1)
PCIe2 x8 (4,1)
Secondary
PCIe 2 x16 riser slot
description
Slot - form factor
4 - FL/FH
PCIe2 x16 (16, 8, 4, 1)
PCIe2 x16 (8, 4, 1)
5 - HL/FH
6 - HL/FH
PCIe2 x8 (8, 4, 1)
Component identification 82