Table of Contents
Advertisement
8.
After choosing the port members, click "Send to Device" to write the settings into the
switch. This might take a few seconds.
V
e
r
i
f
y
i
n
g
V
e
r
i
f
y
i
n
9.
After finishing the above configuration, the ports of the switch will belong to router's
different LAN subnet. We can connect a computer to the switch on different ports and
verify which LAN subnet we are in by checking the IP address obtained. First, we connect
to switch's port 8. By using command "ipconfig", we can see that the computer obtained
an IP 192.168.2.10, which belongs to router's LAN2.
Next, connect to port 16, renew the IP address, and we'll obtain IP 192.168.3.10, which
means we're in router's LAN3 subnet.
Finally, connect to the switch by port 24, and we'll get an IP address 192.168.4.10 which
means we're in router's LAN4 subnet.
Thus we can verify that the VLAN settings are done without even logging into the switch.
470
t
h
e
s
e
t
t
i
n
g
s
g
t
h
e
s
e
t
t
i
n
g
s
Vigor3220 Series User's Guide
Advertisement
Table of Contents
