Table of Contents
Advertisement
Src IP Start
Src IP End
Dest IP Start
Dest IP End
Dest Port Start
Dest Port End
Move UP/Move Down
Wizard Mode
Advance Mode
To use Wizard Mode, simple do the following steps:
1. Click the Wizard Mode radio button.
2. Click Index 1. The setting page will appear as follows:
Available settings are explained as follows:
Item
Source IP
Destination IP
3. Click Next to get the following page.
170
Display the IP address for the start of the source IP.
Display the IP address for the end of the source IP.
Display the IP address for the start of the destination IP.
Display the IP address for the end of the destination IP.
Display the IP address for the start of the destination port.
Display the IP address for the end of the destination port.
Use Up or Down link to move the order of the policy.
Allow to configure frequently used (simple and basic)
settings of route policy via three setting pages.
Allow to configure detailed settings of route policy.
Description
Any – Any IP can be treated as the source IP.
Src IP Start - Type the source IP start for the specified WAN
interface.
Src IP End - Type the source IP end for the specified WAN
interface. If this field is blank, it means that all the source
IPs inside the LAN will be passed through the WAN
interface.
Any – Any IP can be treated as the destination IP.
Dest IP Start- Type the destination IP start for the specified
WAN interface.
Dest IP End - Type the destination IP end for the specified
WAN interface. If this field is blank, it means that all the
destination IPs will be passed through the WAN interface.
Vigor3220 Series User's Guide
Advertisement
Table of Contents
