Auto Switch-Off Setting - M2TECH MARLEY User Manual

marley
DUAL-DRIVE CLASS-A HEADPHONES AMPLIFIER
REVISION P .A – OCTOBER 2013
R
The desired volume display mode is selected by rotating the encoder knob:
"DECIBELS" or "STEPS".
To confirm the selected volume display mode, push the encoder: the volume display
mode will be set and the unit will revert to "idle" status.
On the other hand, if the user changes her/his minds and goes for keeping the
volume display mode previously set, she/he only needs to push the button to the left
of the front panel (Figure 1, 1) or avoid doing any other action on the unit: after a few
seconds, the MARLEY automatically reverts to its "idle" status without changing the
volume display mode.
NOTE: The choice of either mode won't affect the way volume is actually set:
the MARLEY MARLEY MARLEY allows for setting volumes between 0 and -78dB with 1dB step. MARLEY
Volume display only is changed depending on the choice made as indicated
above.

6.7. Auto Switch-Off Setting

Compliant to UE rules about energy saving, the MARLEY is able to automatically switch
off after a certain time of idle operation. Idle means a time lapse in which user doesn't
operate on the units' controls.
Auto switch-off time is user settable (30 to 240 minutes in 30 minutes steps); auto
switch-off may be disabled. To do any of the two, it is necessary to push the encoder
five times in balanced mode or six times in dual single-ended mode: the auto switch-
off selection feature is then accessed as shown in Figure 11.
24
M2Tech
www.m2tech.biz
Copyright © 2013, M2Tech Srl