SawStop CNS175 Owner's Manual page 69

Making Adjustments to Your Saw
45° Tilt Limit Stop
To check the position of the 45° limit stop, install a 10 inch saw blade on the arbor (see page 29). Raise
the blade to its full elevation, and turn the tilt hand wheel clockwise until the limit stop is reached. Using a
combination square, check to see that the blade is at a 45° angle to the table (see Fig. 88). If you need to adjust
the position of the 45° limit stop follow
the instructions below.
The 45° tilt limit stop is determined by
the set screw in the cast iron table top
located to the right of the front of the table
opening (see Fig. 87). Use the included
3 mm hex key to turn the screw counter-
clockwise several turns.
Next, adjust the tilt hand wheel until the
blade is at 45° to the table. Turn the 45°
limit set screw clockwise until it is tight.
The 45° limit stop has now been set.
Tilt Angle Indicator
The tilt angle indicator is located at the front of the contractor saw, just behind the elevation handwheel (see
Fig. 89). The indicator shows the current angle of the blade relative to vertical (i.e., perpendicular to the table
top).
Once the 0° limit stop is correctly set, turn the tilt handwheel
counter-clockwise until the limit stop is reached. Check the
reading of the tilt angle indicator. If necessary adjust the indicator
by loosening the locking screw with the included 5 mm hex key
and rotating the indicator until it reads 0°. Lock the indicator in
place by tightening the locking screw.
Fig. 88
locking
screw
tilt angle
indicator
SawStop 10" Contractor Saw
Fig. 89
67