3.3 How to Set up Rate Limiting for Bandwidth Control?
The example instructs how to set up rate limiting for each station traffic
rate. In this example, downlink is to set the maximum incoming
transmission data rate, and uplinks is to set the maximum outgoing
transmission data rate for each client connected to specific SSID.
Figure 10 Uplink and Downlink Rate Limiting per Station
Note:
All network IP addresses and subnet masks are used as examples in this article.
Please replace them with your actual network IP addresses and subnet masks. This
example was tested using USG20v2 (Firmware Version: V4.15), NXC5500 (Firmware
Version: 5.10), GS2210-8HP (Firmware Version: V4.30)
www.zyxel.com
.
70/225