2.2 How to Set up Fail Over/Fall Back?
The example instructs how to set up fail over and fall back. All
management APs connect to NXC controller 1 in this example. When
the NXC controller 1 fails to connect, all managed APs are controlled by
NXC controller 2 by fail over setting. Once NXC controller 1 works again,
the APs are back to NXC controller 1 via fall back setting.
Figure 5 Fail Over and Fall Back
Note:
All network IP addresses and subnet masks are used as examples in this article.
Please replace them with your actual network IP addresses and subnet masks. This
example was tested using USG20v2 (Firmware Version: V4.15), NXC2500 (Firmware
Version: 5.10), GS2210-8HP (Firmware Version: V4.30)
www.zyxel.com
.
41/225