Installation And Usage Conditions; Installation And Operating Conditions - YASKAWA MP3300 series Product Manual

4.1 Installation and Usage Conditions

4.1.1 Installation and Operating Conditions

4.1

Installation and Usage Conditions

4.1.1

Installation and Operating Conditions

The installation and usage conditions for the Machine Controller are given in the following table.
Environmental
Conditions
Mechanical
Operating
Conditions
Electrical
Operating
Conditions
Installation
Conditions
4-2
Item
Ambient Operating
Temperature
Ambient Storage Temperature
Ambient Operating Humidity
Ambient Storage Humidity
Pollution Level
Corrosive Gas
Operating Altitude
Vibration Resistance
Shock Resistance
Noise Resistance
Ground
Cooling Method
Specification
0 to 60°C (Forced cooling is required if 55°C is
exceeded.)
-25 to 85°C
10% to 95% RH (with no condensation)
10% to 95% RH (with no condensation)
Conforms to JIS B 3502 Pollution Degree 2.
There must be no combustible or corrosive gas.
2,000 m max.
Conforms to JIS B 3502.
• Continuous vibration: 5 to 9 Hz with single-amplitude
of 1.75 mm
9 to 150 Hz with fixed acceleration of 4.9 m/s
• Intermittent vibration: 5 to 9 Hz with single-amplitude
of 3.5 mm
9 to 150 Hz with fixed acceleration of 9.8 m/s
10 sweeps each in X, Y, and Z directions for both inter-
mittent and continuous vibration
Size of shock: Peak acceleration of 147 m/s
Duration: 11 ms
3 times each in X, Y, and Z directions
Conforms to EN 61000-6-2, EN 61000-6-4, and EN
55011 (Group 1 Class A).
Power supply noise (FT noise): ±2 kV min. for one min-
ute
Radiation noise (FT noise): ±1 kV min. for one minute
Ground noise (impulse noise): ±1 kV min. for 10 min-
utes
Electrostatic noise (contact discharge method): ±6 kV
or more, 10 times
Ground to 100 Ω max.
Natural cooling or forced-air cooling
Refer to the following section for details.
4.1.2 Control Panel Cooling Method on page 4-3
2
2
2
(15 G)