Ricoh ft5035 User Manual page 162

Copier
If translucent paper cannot be stacked well on the copy tray, change the paper
direction so that the paper grain is oriented with the paper path.
To avoid problems caused by curly copies, try turning over the paper stack in the
500-sheet or large capacity tray. If there is no improvement, change to copy
paper with less curl.
Load paper with the copy side down in the 500-sheet trays, and with the copy
side up in the large capacity tray. If copies are curled, try turning the copy paper
over in the tray. If there is no improvement, change to copy paper with less curl.
Leading and side edges of the original image are not copied, as shown in the
illustration.
a
Paper feed direction
<One-sided copy>
Full Size magnification
b1
a = 3.5 ± 2.5 mm
Other
a = 3.5 ± 2.5 mm
<Two-sided copy>
(from one-sided originals to a two-sided copy)
Full Size magnification
b2
*a = 8.5 ± 3 mm
*As a right margin (5 mm) is set on the back side,
this value varies.
Other
a ≤ 4 mm
REMARKS
b1 + b2 ≤ 4 mm
b1 + b2 ≤ 10 mm
b1 + b2 ≤ 4 mm
b1 + b2 ≤ 4 mm
REMARKS
159