Ricoh ft5035 User Manual page 102

Copier's condition
C code is displayed on the
copy counter.
U code is displayed on the
copy counter.
E code is displayed on the copy
counter.
IF YOUR COPIER DOES NOT OPERATE AS YOU WANT
C1 Close the copier's front cover.
Close the side cover of the optional paper tray
C3
unit.
Close the cover of the large capacity tray.
C4
Close the cover of the optional 20-bin multi-
position sorter stapler, or set the sorter stapler
correctly.
Close the cover of the optional 20-bin sorter
C5
stapler, or set the sorter stapler correctly.
Close the cover of the optional 10-bin sorter
stapler, or set the sorter stapler correctly.
Close the cover of the optional 20-bin sorter.
C6 Close the cover of the optional document feeder.
Close the copier's side cover or large capacity
C7
tray.
The copier is set for user codes. Enter your user
code (3 digits).
U2
Insert the optional key counter.
Set the fusing unit correctly.
U6
the position of the fusing unit.
Set the unit for two-sided copying correctly.
U7
See page 4 for the position of the unit.
Set the stapler unit of the 20-bin multi-position
U8
sorter stapler.
Turn the main switch off, wait a few seconds,
and then turn it on. If the E code appears again,
call your service representative and tell which
code is on. Check the code as follows:
ex.)
E 1 0 1
By pressing the Decimal Point
key, this code is displayed.
This code is displayed first.
Action
See page 4 for
See page 107.
99