Input And Output Connections - Samson SM10 Owner's Manual

Input and Output Connections

16. Mic/Line Inputs (channels 1
and 2) - Use these Combo
XLR plus 1/4" jacks to
connect a microphone
or line level signal to
1
channels 1 and 2. The
XLR inputs provide
48-volt phantom power
for use with condenser
microphones.
17. Line Inputs - Use these balanced 1/4" jacks to connect line level sources such
as synthesizers, drum machines, MP3 players, or effects processors to any of
the 8 channels. When connecting monophonic (as opposed to stereo) signal
sources, use the left inputs; the Balance control for that channel will then act
as a constant level pan control.
3
18. Input Level Switch – Use this switch to independently set the sensitivity of
channels 1-8 line level inputs. When the switch is in the up position the
input are set to +4dBu. When the switch is depressed the input is set to
-10dBv.
19. Stereo LINE IN (channels 9-10) – Two stereo 1/4" jacks for
25
connecting stereo line level sources like those from the
outputs of effects processors. These inputs can also be
used to link multiple SM10's or to add the output from
another mixer to the SM10 without taking up channel line
inputs.
20. MON Output – The signals present at the MON stereo 1/4"
output are sent from the MON send, which are fed from
the input channels' MON control knobs. In a live sound
situation this can be used to create a monitor mix by
connecting the MON output to a power amp and monitor
speaker.
21. EFX Output – The stereo 1/4" EFX Output is used to send a
signal to an external signal processor such as a delay or reverb. The signal
present at the EFX Output is sent from the EFX bus, which is fed from the
input channel's EFX control knob.
10
2 5
4
24
8
18
17
23
10
16
22 20
21
14 15
19