Mitsubishi Electric FR-E 500 Instruction Manual page 184

Operation Panel Indication
Name
Description
Check point
Corrective action
Operation Panel Indication
Name
Description
Check point
Corrective action
Operation Panel Indication
Name
Description
Check point
Corrective action
(2) Minor fault
The output is not shut off when the protective function is activated. You can make
parameter setting to output the minor fault signal. (Set "98" in any of Pr. 190 to Pr. 192
(output terminal function selection). Refer to page 150.)
Operation Panel Indication
Name
Description
Check point
Corrective action
E. 3
Option fault
Also stops the inverter output if the dedicated option used in
the inverter results in setting error or connection (connector)
fault.
• Check that the function setting and operation of the option
are correct.
• Check that the communication option is plugged in the
connector securely.
• Connect the communication option securely.
• Contact your sales representative.
E. 6
E. 7
CPU error
This function stops the inverter output if a communication
error occurs in the built-in CPU.
Please contact your sales representative.
E. LF
Output phase failure protection
This function stops the inverter output if one of the three
phases (U, V, W) on the inverter's output side (load side)
results in open phase.
• Check the wiring (Check the motor for a fault.)
• Check that the capacity of the used motor is not smaller
than the inverter capacity.
• Wire the cables properly.
• Check the setting of Pr. 251 "output phase failure protection
selection".
FN
Fan fault
For the inverter which contains a cooling fan, FN appears on
the operation panel when the cooling fan stops due to a fault
or operates differently from the setting of Pr. 244 "cooling fan
operation selection".
Check the cooling fan for a fault.
Change the fan.
168
PROTECTIVE FUNCTIONS
FR-PU04 Fault 3
Fault 6
FR-PU04
Fault 7

FR-PU04 E. LF
FR-PU04 Fan Failure
5