Control Circuit Examples - Danfoss MCD3000 Series Manual

Control circuit examples

Example 1. A basic installation where motor operation
is controlled using the MCD3000 Local Control Panel.
Notes:
1. The MCD3000 must be in local mode to function
with this circuit. Use the [LOCAL/REMOTE] push
button to switch between local and remote
modes.
MG.15.A2.22 – VLT is a registered Danfoss trademar
MCD3000 Series
Example 2. MCD3000 installed with a line contactor
and operated via a remote two wire start circuit with
reset push button.
Notes:
1. The MCD3000 must be in remote mode to
function with this circuit. Use the
[LOCAL/REMOTE] push button to switch between
local and remote modes.
2. Relay Output A must be programmed for the Line
Contactor function. Refer Par. 36 Relay A -
Function Assignment.
11