Adjusting The Recline Angle Using The Base - CYBEX CLOUD Q Manual

ADJUSTING THE RECLINE ANGLE USING THE BASE

It is very important for your child's safety that this child restraint be
installed at the correct recline angle. Before attaching the Infant Carrier
to the Base, always check the Level Indicator for the correct recline angle
range based on your child's weight.
DO NOT use this or any other child restraint with a premature,
low birth weight, or medically fragile infant, until after you have
consulted with your doctor. Some medical problems when
placed in a seated position.
If the child restraint is TOO UPRIGHT, the child's head may fall
forward and cause breathing problems.
If the child restraint is TOO RECLINED crash protection will be
reduced. Failure to properly recline the child restraint on the
vehicle seat increases the risk of Death or serious injury.
ADJUST RECLINE ANGLE
1. Squeeze the Level Adjustment Handle to extend or retract the Leveling
Foot until the Base is within the recommended range for your child.
There are four recline positions.
2. Release handle to lock Foot in place.
3. Install Base. Be sure to check for correct recline angle after installation
If the Recline Angle is not correct after installation, uninstall the base, adjust Leveling Foot and reinstall.
Vehicle must be on a level surface for the Level Indicator to function correctly
21