Adjusting The Recline Angle; When Using The Base - CYBEX ATON Owner's Manual

It's very important for your child's safety that this child restraint be installed at the correct angle.
DO NOT use this or any other child restraint with a premature, low birth weight, or medically
fragile infant, until after you have consulted with your doctor. Some infants may have dif culty
breathing or have other medical problems when placed in a seated position.
If the child restraint is TOO UPRIGHT, the child's head may fall forward and cause breathing
problems. If the child restraint is TOO RECLINED crash protection will be reduced.
FAILURE TO properly recline the child restraint on the vehicle seat increases the risk of DEATH or
SERIOUS INJURY.

When using the Base

Before attaching the Infant Carrier, always check the
Level Indicator for the correct recline angle based on
child's weight.
Vehicle must be on a level surface for the Level
Indicator to function correctly.
To Adjust Angle
1. Uninstall Base. Squeeze the Level Adjustment
Handle to raise or lower the Leveling Foot. Release
handle when the Base is at the correct angle.
2. Check to see if the recline angle is correct
after you have installed the Base.
If the Recline Angle is not correct after installation,
uninstall the base, adjust Leveling Foot and
reinstall.
36

Adjusting the Recline Angle

OR