Adjusting The Recline Angle Using The Base - CYBEX ATON 2 Owner's Manual

It is very important for your child's safety that this child restraint be installed
at the correct recline angle. Before attaching the Infant Carrier to the Base,
always check the Level Indicator for the correct recline angle range based
on child's weight.
DO NOT use this or any other child restraint with a premature, low birth
weight, or medically fragile infant, until after you have consulted with
your doctor. Some infants may have dif culty breathing or have other
medical problems when placed in a seated position.
If the child restraint is TOO UPRIGHT, the child's head may fall forward
and cause breathing problems. If the child restraint is TOO RECLINED
crash protection will be reduced.
FAILURE TO properly recline the child restraint on the vehicle seat
increases the risk of DEATH or SERIOUS INJURY.
Vehicle must be on a level surface for the Level Indicator to function
correctly.
Adjust Recline Angle
1. Squeeze the Level Adjustment Handle to extend or retract
the Leveling Foot until the Base is within the recommended
range for your child. There are four recline positions.
2. Release handle to lock Foot in place.
3. Install Base. Be sure to check for correct recline angle after installation.
If the Recline Angle is not correct after installation, uninstall the base,
adjust Leveling Foot and reinstall.

Adjusting the Recline Angle Using the Base

25