Adjusting The Recline Angle Using The Base - CYBEX CLOUD Q Owner's Manual

ADJUSTING THE RECLINE ANGLE USING THE BASE

It is very important for your child's safety that this child
restraint be installed at the correct recline angle. Before
attaching the Infant Carrier to the Base, always check the Level
Indicator for the correct recline angle range based on your
child's weight.
DO NOT use this or any other child restraint with a
premature, low birth weight, or medically fragile infant,
until after you have consulted with your doctor. Some
infants may have difficulty breathing or have other
medical problems when placed in a seated position.
If the child restraint is TOO UPRIGHT, the child's head
may fall forward and cause breathing problems.
If the child restraint is TOO RECLINED crash
protection will be reduced.
Failure to properly recline the child restraint on the
vehicle seat increases the risk of Death or serious
injury.
Vehicle must be on a level surface for the Level Indicator to function
correctly.
ADJUST RECLINE ANGLE
1. Squeeze the Level Adjustment Handle to extend or retract
the Leveling Foot until the Base is within the recommended
range for your child. There are four recline positions.
2. Release handle to lock Foot in place.
3. Install Base. Be sure to check for correct
recline angle after installation.
If the Recline Angle is not correct after installation, uninstall the base,
adjust Leveling Foot and reinstall.
29