A.2.2 Feedback Cable Part Numbers - Baldor MotiFlex e100 Installation Manual

A.2.2 Feedback cable part numbers

The Baldor part number for a feedback cable is derived as follows:
CBL 020
m ft
0.5 1.6
1.0 3.3
1.5 4.9
2.0 6.6
5.0 16
Other lengths
available on
request.
Examples:
A 2 m encoder feedback cable for a MicroFlex e100 drive, with required connectors at both ends,
has part number CBL020SF-E2.
A 1 m EnDat cable for a MintDrive
has part number CBL010SF-D1S.
Baldor feedback cables have the outer shield tied to the connector housing(s). If you are not
using a Baldor cable with your chosen feedback device, be sure to obtain a cable that is a
shielded twisted pair 0.34 mm
should not exceed 30.5 m (100 ft) in length. Maximum wire-to-wire or wire-to-shield capacitance
is 50 pF per 300 mm (1 ft) length, to a maximum of 5000 pF for 30.5 m (100 ft).
A.2.3 Ethernet cables
The cables listed in this table connect MotiFlex e100 to other EPL nodes such as
NextMove e100, additional MotiFlex e100s, or other EPL compatible hardware. The cables are
standard CAT5e shielded twisted pair (S/UTP) 'crossover' Ethernet cables:
Cable assembly description Cable assembly description
CAT5e Ethernet cable
A-10 Accessories
SF -E 1
SF Servo motor
feedback cable
with at least 1
connector
RF Raw cable
(no connector)
II
, with drive connector and stainless steel motor connector,
2
(22 AWG) wire minimum, with an overall shield. Ideally, the cable
S
E Incremental -
encoder
1
D BiSS
EnDat
SinCos
2
R Resolver
S SSI
Baldor catalog number Baldor catalog number
CBL002CM-EXS
CBL005CM-EXS
CBL010CM-EXS
CBL020CM-EXS
CBL050CM-EXS
CBL100CM-EXS
www.baldormotion.com
Raw cable - Standard
connector
II
FlexDrive
II
Flex+Drive
S Stainless
II
MintDrive
steel
connector
e100
Length
m
0.2
0.5
1.0
2.0
5.0
10.0
MN1943
ft
0.65
1.6
3.3
6.6
16.4
32.8