Installing The Usb Driver - Baldor MotiFlex e100 Installation Manual

6.2.3 Installing the USB driver

It is now necessary to install the USB driver. When the MotiFlex e100 is powered, Windows will
automatically detect the controller and request the driver.
1. Follow the on-screen instructions to select and install the driver. The driver files are available
on the supplied Baldor Motion Toolkit CD. If you are using a copy of the driver located on the
hard disk, USB stick, or another CD, the driver files must all be in the same folder.
2. During installation, Windows may report that the driver is 'unsigned'. This is normal for the
MotiFlex e100 driver, so click the Continue Anyway button to continue with the installation.
When installation is complete, a new Motion Control category will be listed in Windows
Device Manager.
The MotiFlex e100 is now ready to be configured using Mint WorkBench.
Note: If the MotiFlex e100 is later connected to a different USB port on the host computer,
Windows may report that it has found new hardware. Either install the driver files
again for the new USB port, or connect the MotiFlex e100 to the original USB port
where it will be recognized in the usual way.
MN1943
www.baldormotion.com
Configuration 6-3