Seat ibiza Owner's Manual page 47

Mileage display or Service Interval Display
60
50
40
30
20
10
0
3 2
M M i i l l e e a a g g e e c c l l o o c c k k / / T T r r i i p p m m i i l l e e a a g g e e
The upper counter registers the total distance driven and the lower
one the short trips.
The last figure of the lower counter indicates 100 m.
The trip mileage can be put back to zero by pressing the reset knob
next to the speedometer (partial mileage clock).
S S e e r r v v i i c c e e I I n n t t e e r r v v a a l l I I n n d d i i c c a a t t o o r r * *
If a service is due the lower indicator (trip mileage indicator) will
display the following maintenance messages:
O O I I L L – engine oil change
I I N N S S P P – maintenance service
Safety First
160
180
200
220
240
14956
260
OI L
IBN-121
Fig. 39
Controls and equipment
The maintenance service will switch off three minutes after the
engine is switched on. You can also change to the trip mileage by
pressing the reset button (for more than 0.5 seconds)
The Technical Service Centre that carries out the maintenance
service will reset the maintenance interval indicator once the
service is done.
I I t t i i s s r r e e c c o o m m m m e e n n d d e e d d t t h h a a t t r r e e p p a a i i r r a a n n d d m m a a i i n n t t e e n n a a n n c c e e w w o o r r k k b b e e c c a a r r r r i i e e d d
o o u u t t e e x x c c l l u u s s i i v v e e l l y y b b y y a a T T e e c c h h n n i i c c a a l l S S e e r r v v i i c c e e C C e e n n t t r r e e . .
The service interval indicator can also be reset with the trip
mileage button. Proceed as follows:
1 – "Ignition OFF"
2 – Keep pressing the "reset" button of the trip mileage clock.
3 – "Ignition ON" while pressing the "reset" button. The current
event will be statically displayed.
4 – After at least 10 seconds release the reset button.
a) With an event:
– If the button is not released the indication "----" will be
displayed and the event is reset.
b) With several events:
– The first event is reset and the following event is indicated
statically according to the priorities.
– Repeat the procedure (from point 1 on) for the next event.
1) With "Ignition OFF" the maintenance indication remains visible on the display.
Tips and Maintenance
Instrument panel
1) .
Technical Data
45