Seat ibiza Owner's Manual page 187

Hide thumbs Also See for ibiza:
Table of Contents

Advertisement

• Depressions under vehicle for jack:
W W A A R R N N I I N N G G
I I f f t t h h e e j j a a c c k k i i s s n n o o t t f f i i t t t t e e d d a a t t t t h h e e p p o o i i n n t t s s m m a a r r k k e e d d o o r r d d e e s s c c r r i i b b e e d d , , d d a a m m a a g g e e c c o o u u l l d d b b e e
c c a a u u s s e e d d t t o o t t h h e e v v e e h h i i c c l l e e . . T T h h e e r r e e i i s s a a l l s s o o a a r r i i s s k k o o f f i i n n j j u u r r y y ! !
– The jack should be placed at some 17 cm in front and
approximately 21 cm away at the rear from the corresponding
wheel track
fig.
141.
• Place the jack under the vehicle:
The
fig. 142
shows the jack fitted on the rear left hand side.
W W A A R R N N I I N N G G
I I f f t t h h e e g g r r o o u u n n d d u u n n d d e e r r t t h h e e j j a a c c k k i i s s t t o o o o s s o o f f t t , , t t h h e e v v e e h h i i c c l l e e c c o o u u l l d d s s l l i i p p o o f f f f t t h h e e j j a a c c k k . .
E E n n s s u u r r e e , , t t h h e e r r e e f f o o r r e e , , t t h h a a t t t t h h e e j j a a c c k k i i s s o o n n a a s s o o l l i i d d s s u u r r f f a a c c e e . . I I f f n n e e c c e e s s s s a a r r y y , , u u s s e e a a
l l a a r r g g e e , , s s t t a a b b l l e e u u n n d d e e r r l l a a y y t t o o p p l l a a c c e e u u n n d d e e r r t t h h e e j j a a c c k k . .
I I f f t t h h e e g g r r o o u u n n d d u u n n d d e e r r t t h h e e j j a a c c k k i i s s s s l l i i p p p p e e r r y y , , p p l l a a c c e e a a n n o o n n - - s s l l i i p p r r u u b b b b e e r r m m a a t t
u u n n d d e e r r n n e e a a t t h h . .
N N o o t t e e
• In vehicles fitted with a plastic cover*, remove the cover to access the
attachment points of the vehicle. For this proceed as follows:
Pull on the cover and remove from its housing.
Once the cover is removed, it will remain suspended by a rubber to avoid its
loss.
Safety First
Controls and equipment
– Wind jack arm up by turning the crank in the spindle until the
jack just goes under the vehicle.
– The claw of the jack must fit round the vertical rib on the side
member so that the jack cannot slip when vehicle is lifted
142.
– Align jack and at same time wind claw up further until it contacts
the vertical rib on side member.
• Lift vehicle until the wheel is just clear of the ground.
Removing and fitting the wheel
• Remove wheel bolts (a a f f t t e e r r l l o o o o s s e e n n i i n n g g ), using box spanner in
screwdriver handle
fig.
143, place them on a clean surface (hub
cap, cloth, paper) next to the jack and remove wheel.
Tips and Maintenance
If and when
fig.
K
B45-085C
Fig. 143
Technical Data
185

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents