Table of Contents
Advertisement
TROUBLESHOOTING — CONTINUED
Problem:
Nozzle is too low to print bed and that cause filament blockage,
because of high back pressure in print head.
Solution:
Level the print bed with auto
calibration or three screws and/or
change the settings to the correct
bed coating.
After leveling remove filament
cut the end at angle and insert it
again.
Problem:
Material is low quality.
Solution:
Try to print with different material.
Problem:
There is some dust inside the nozzle which blocks filament
extruding.
Solution:
Heat up print head ~30C above normal material printing
temperature and try to extrude filament manually by hand.
Repeat this few times. Is that doesn't help there is need of nozzle
change.
Print not sticking to bed
Things to make part adhesion better:
•
Use right bed coating, as a universal solution we suggest
to use BuildTak surface, also remember to change "Bed
coating" type in printer menu
•
Print first layer slower (15-25mm/s)
•
Use brim or raft
•
Turn part cooling fans off for first layer
•
Increase print bed temperature
•
Rotate model on print bed to get the largest possible surface
to print bed
•
Level print bed with auto calibration function or with 3
screws
•
Move nozzle little bit lower to print bed ("Bed coating"-
>"Custom"->reduce the number little bit)
43
Hide quick links:
Advertisement
Table of Contents
