Safety - Mass Portal Pharaoh XD Series User Manual

WARNING The
nozzle and the glass
plate below the print
head are extremely
hot when printing. Do
not touch.
TIP Use paper towel
to clean the nozzle
from excess material
before printing. This
must be done when
the nozzle is heated,
please use extreme
caution.
4

Safety

Mass Portal® 3D printer is an electro-mechanical
robotic device that has hot and moving parts when
operating. You should always operate the printer with
caution and follow the instructions in this manual.
INDOOR USE ONLY
The printer is intended to be used only indoors — ambient
temperature must be between 15°C and 30°C. The Mass Portal
3D printer under no circumstances should be subjected to high
levels of humidity, excess heat, water, frost or other condition
which may damage the electronics or mechanical parts. When
transported or unpacked, it must be left to warm up to room
temperature before operation.
SAFE PLACEMENT
The printer, filament and power cable must be placed so that it
cannot be unintentionally touched or hooked by clothing. The
printer is considerably heavy, extra care must be taken when
moving. Do not use unnecessary force.
HOT SURFACES AND PARTS
To avoid burns and physical damage do not touch the printer's
head and heated print bed unless they have cooled down to
40°C or less. These temperatures are displayed on the built in
touch screen display and in the printing software interface. If in
doubt, double check. Keep in mind that the readings could be
incorrect.
HOT PRINT BED
The glass print bed can be heated up to 120°C. Remember
that adjacent metal surfaces can be warm. When at room
temperature, print bed can be sprayed lightly with non-flammable
consumer plastics or glass cleaner and then wiped off with a
clean wipe.
HOT PRINT HEAD
Print head heating block and nozzle can be heated up to 300°C.
Keep in mind that surrounding parts can be hot.
HOT MELTED PLASTIC
The melted plastic extruded from the nozzle can reach near
300°C. Care and caution must be taken when operating.