Mass Portal Pharaoh XD Series User Manual page 9

7. Calibrate the printer.
After turning on the printer it is necessary to calibrate the printer
to make sure that the bed is level. (Before starting make sure the
print bed is clear of any objects)
Calibration process for MP20
1. From the home screen select "Settings"
2. Select the "Calibration" option
3. Select "Calibrate" and the printer will go through the automatic
calibration process
4. The printer is calibrated and ready for printing!
Calibration process for MP30 and MP40
1. From the home screen select "Settings"
2. Select the "Calibration" option
3. Make sure that before starting the calibration process that you
have the calibration coin prepared.
4. Select "Calibrate"
5. When the calibration process begins, the print head will slowly
lower to three locations on the print bed. When the head starts
going down, place the coin on the build plate under the inductive
sensor for the printer to take a measurement.
6. The printer will run a verification process so you will need to
repeat step 5 one more time.
7. The printer is calibrated and ready for printing!
9