Mass Portal Pharaoh XD Series User Manual page 17

VENTILATION CONTINUED
Chamber Temperature
*Approximate temperatures depending on which ventilation option is used
MP20 MP30 MP40
500C 300C 250C
Ventilation Settings
To use the ventilation system properly, there are few different
options available to use for multiple purposes
Circulation
Circulation is used for materials the generally do not need a
warm print chamber. Material such as PLA, PLA composite
materials, XT, flexible materials, etc. The circulation creates an
airflow through the print chamber so that the chamber will not
become too warm for the printed part.
Filtration
Filtration is used for materials that will possibly emit toxic fumes
while printing.
Slow Extraction
The slow option should be used while printing to filter the air
during the print without creating too much of a cooling effect in
the chamber
Fast Extraction
The fast option should be used when the print is finished so that
all of the air in the chamber can quickly be filtered. Once the air
is filtered, you can open the front door and remove the finished
print.
Off
Use the "Off" option when the material you are using would
benefit from a heated chamber, materials such as PC. Can also
use the filtration options for such materials as well.
17