Configuration; Configuration Of Et 200Pro With Fail-Safe Modules - Siemens SIMATIC Operating Instructions Manual

Configuration

2.1

Configuration of ET 200pro with Fail-Safe Modules

Introduction
You can configure ET 200pro distributed I/O systems with standard and fail-safe modules.
This chapter presents an example configuration.
Configuration Example for ET 200pro with Fail-Safe Modules
The figure below presents a configuration example with standard and fail-safe modules
within an ET 200pro.
Figure 2-1
①
②
③
④
⑤
ET 200pro Distributed I/O System - Fail-Safe Modules
Operating Instructions, 05/2007, A5E00394073-02
Configuration Example for ET 200pro with Fail-Safe Modules
CM IM DP Direct connection module for the interface module
IM 154-2 DP HIGH FEATURE (PROFIBUS DP) interface module (6ES7 154-2AA00-0AB0)
IM 154-4 PN HIGH FEATURE (PROFINET IO) interface module (6ES7 154-4AA00-0AB0)
Connection modules for the electronic modules
Terminating module
Heavy-gauge threaded joints for cables at the connection module
2
19