Inserting And Removing Fail-Safe Connection Modules And Electronic Modules - Siemens SIMATIC Operating Instructions Manual

Terminal Assignment of Connection Modules
The terminal assignment of the connection modules depends on which electronic module is
inserted.
See also
Block Diagram of 8/16 F-DI DC24V PROFIsafe Electronic Module (Page 58)
Wiring of Inputs of 8/16 F-DI DC24V PROFIsafe Electronic Module (Page 63)
Use Case 1: Safety Mode SIL2/Category 3 (Page 65)
Use Case 2: Safety Mode SIL3/Category 3 (Page 67)
Use Case 3: Safety Mode SIL3/Category 4 (Page 77)
Wiring the 4/8 F-DI/4 F-DO DC24V/2A PROFIsafe Electronic Module's Inputs (Page 96)
Wiring of Outputs of the 4/8 F-DI/4 F-DO DC24V/2A PROFIsafe Electronic Module (Page 97)
Block Diagram of the F-Switch PROFIsafe Electronic Module (Page 109)
Wiring of Inputs of the F-Switch PROFIsafe Electronic Module (Page 114)
Use Case 1: Safety Mode of F-Switch PROFIsafe (Page 116)
Use Case 2: Safety Mode SIL3/Category 3 (Page 116)
Use Case 3: Safety Mode SIL3/Category 4 (Page 125)
4.3 Inserting and removing fail-safe connection modules and electronic
modules
Inserting and Removing Modules
Fail-safe modules in ET 200pro are inserted and removed in the same way as all standard
modules in an ET 200pro.
Inserting and Removing Modules During Operation
F-modules can be removed and inserted during operation in exactly the same way as
standard modules in ET 200pro.
Follow the instructions in the
Distributed I/O Device
ET 200pro Distributed I/O System - Fail-Safe Modules
Operating Instructions, 05/2007, A5E00394073-02

4.3 Inserting and removing fail-safe connection modules and electronic modules

"Maintenance and Service"
manual.
ET 200pro
chapter in the
Wiring
29