4.3 Memory module
4.3
Memory module
Caution: The power of the computer must be turned off when you remove the memory
module. Removing a memory module with the power on risks damaging the
module or the computer itself.
Do not touch the memory module terminals. Any dirt on the terminals may
cause memory access problems.
Never press hard or bend the memory module.
Removing the memory module
To remove a memory module, confirm that the computer is in boot mode. Then perform
the following procedure (See. Figure 4-3, 4-4)
1. Turn the computer upside down.
2. Remove the following screws fixing the memory slot cover.
• M2×2.5B SPECIAL HEAD screw
M2×2.5B SPECIAL HEAD
3. Remove the memory slot cover.
Portage 2000 Maintenance Manual (960-333)
Figure 4-3 Removing the memory slot cover
4 Replacement Procedures
x2
Memory slot cover
4-11