Toshiba Portege 2000 Maintenance Manual page 206

4 Replacement Procedures
3. Removing the bezel
1) Place the module with the insulation sheet facing upwards.
2) Unhook latches (five at the top edge and two at the bottom edge) between the
bezel and frame.
3) Peel off slowly the double-adhesive tape of the bezel bottom and remove the
bezel.
Caution:1) When peeling off the latches and the double-faced tapes, be careful not to
damage the FPC.
2) When removing the bezel, do not break it and do not deform the bezel.
Double-adhesive tape within
the bezel.
Figure 4-43 Replacing Toshiba fluorescent lamp(3)
4-54
Release 3 bezel latches.
Peel off the double-adhesive tape slowly.
Portage 2000 Maintenance Manual (960-333)
4.15 Fluorescent Lamp
Double-adhesive tape
within the bezel.
Release 3 bezel latches.
Peel off the double-adhesive
tape slowly.