Usb Floppy Disk Test - Toshiba Portege 2000 Maintenance Manual

3.8 USB Floppy Disk TestUSB Floppy Disk Test
3.8

USB Floppy Disk Test

COUTION: Before running the floppy disk test, prepare a formatted work disk. Remove
the Diagnostics Disk and insert the work disk into the FDD. Otherwise, the contents of the
floppy disk will be erased.
To execute the Floppy Disk Test, select 5-FLOPPY DISK TEST from the DIAGNOSTIC
TEST MENU, press Enter.
1. The following message will appear. Select the kind of drive,the kind of media ,the media
mode and the start track of the floppy disk drive to be tested, press Enter.
Test drive number select (1:FDD#1,2:FDD#2,0:FDD#1&2)?
Media in drive #1 mode (0:2DD,1:2D,2:2D-2HD/2DD,3:2HD)?
2HD Media mode (1:1.20MB/2:1.44MB)
Test start track (Enter:0/dd:00-79)
2. The Floppy Disk test contains five subtests that test the FDD.
The floppy disk test menu will appear after you select FDD test parameters.
SUB-TEST MENU:
01-Sequential read
02-Sequential read/write
03-Random address/data
04-Write specified address
05-Read specified address
99-Exit to DIAGNOSTIC TEST MENU
Select the number of the subtest you want to execute and press Enter. The following
message will appear during the floppy disk test.
Floppy Disk
SUB-TEST
PASS COUNT:XXXXX
WRITE DATA:XXXXX
ADDRESS :XXXXXX
Portege 2000 Maintenance Manual (960-333)
XXXXXXX
ERROR COUNT:XXXXX
READ DATA :XX
STATUS :XXX
3 Tests and Diagnostics
xxx DIAGNOSTIC TEST VX.XX
[Ctrl]+[Break]
[Ctrl]+[C]
;test end
;key stop
3-19