Table of Contents
Advertisement
Chapter 6: Peripheral Devices & Accessories
Charging Batteries
6.6.1 Charging Batteries
•
Slide the battery into a charge well, aligning the contacts on the battery with
the contacts in the charge well.
6.6.2 Battery Charge Duration
A fully discharged battery can take up to 4 hours to charge. The quad battery charger
stops applying power to the battery when it is fully charged
overcharge if the battery remains in the charge well. The 75% charge indicator is
handy if you need a quick recharge
6.6.3 Charge Indicators–The LEDs
Each battery charge well is equipped with an LED to indicate the charge status of
the battery. When a battery is inserted in the charger, the colour and behaviour of the
LED associated with the charge well in use indicates the status of the charge. Refer
to Table 6.3 on page 229 for details.
6.6.4 Troubleshooting
6.6.4.1
The charger is equipped with a recalibration function
discharges and then fully recharges the battery. This process is necessary to
recalibrate the battery capacity gauge internal to the battery. The charger attempts
recalibration when:
•
the battery capacity is at less than 30%, and
•
the battery has undergone more than 40 partial charge cycles since the last
full discharge.
The recalibration function extends the charge time by up to 2 hours.
6.6.4.2
If the indicator flashes red:
•
Remove all batteries and disconnect the mains power cable.
•
Wait at least 20 seconds, and then plug the cable in again.
If any of the charge well LEDs continue to flash red, the charger is defective and
requires service. If all indicators are flashing red, there is a power supply problem
and the charger requires service.
230
WORKABOUT PRO Hand-Held Computer With Windows Mobile 5.0 User Manual
Excessive Charge Duration
Indicator Flashing Red
–
a quick charge often takes less than one hour.
–
a function that fully
–
there is no risk of
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
