Agilent Technologies N6700 Series User Manual page 85

[SOURce:]LIST:VOLTage[:LEVel] <volt> {,<volt>}, (@<list>)
[SOURce:]LIST:VOLTage[:LEVel]? (@<chanlist>)
[SOURce:]LIST:VOLTage:POINts? (@<chanlist>)
[SOURce:]STEP:TOUTput {ON|OFF}, (@<chanlist>)
[SOURce:]STEP:TOUTput? (@<chanlist>)
[SOURce:]VOLTage[:LEVel][:IMMediate][:AMPLitude]
{<value>|MIN|MAX}, (@<list>)
[SOURce:]VOLTage[:LEVel][:IMMediate][:AMPLitude]? (@<chanlist>)
[SOURce:]VOLTage[:LEVel]:TRIGgered[:AMPLitude]
{<value>|MIN|MAX}, (@<list>)
[SOURce:]VOLTage[:LEVel]:TRIGgered[:AMPLitude]? (@<chanlist>)
[SOURce:]VOLTage:MODE {FIXed|STEP|LIST}, (@<chanlist>)
[SOURce:]VOLTage:MODE? (@<chanlist>)
Series N6700 User's Guide
This command specifies the voltage setting for each list step in volts.
Applies only to models with list capability. Up to 512 steps may be
programmed. The values are separated by commas.
The *RST value = 1 step with a value of MIN.
This query returns the number of points (steps) in the voltage list,
not the point values. Applies only to models with list capability.
This command specifies whether an output trigger signal is generated
when a transient voltage or current step occurs. The state is either
ON (1) or OFF (0). A trigger is generated when the state is True.
The *RST value = OFF.
These commands set the immediate and the triggered voltage level of
the output channel. The values are programmed in volts. The
immediate level is the output voltage setting. The triggered level is a
stored value that is transferred to the output when a Step transient is
triggered. Note that the [SOURce:]VOLTage command is coupled with
[SOURce:]VOLTage:RANGe..
The *RST value = MIN.
These commands determine what happens to the output voltage
when the transient system is initiated and triggered.
FIXed The output voltage remains at the immediate value.
STEP The output goes to the triggered level when a trigger occurs.
LIST The output follows the programmed list step value when a trigger occurs.
This function does not apply to all models (see
The *RST value = FIXed.
Source Subsystem
Chapter 1, "Model Differences")
.
85