Agilent Technologies N6700 Series User Manual page 33

Menu Command
System DigPort
Preferences
Error
Calibrate
About
Series N6700 User's Guide
Pin 1 Function
Polarity
Pin 2 Function
Polarity
Pin 3 Function
Polarity
Data
Display
Keys
Security ResetNVRam
State
Sequence VProg
VMeas
CMRR
IProg
IMeas
DPRog
IPeak
Date
Save
Password
Frame
Module
Control Description
Specifies the pin function: DigIO, TrigIn, TrigOut, DigIn, or FaultOut..
Specifies the pin polarity.
Specifies the pin function: DigIO, TrigIn, TrigOut, or DigIn.
Specifies the pin polarity.
Specifies the pin function: DigIO, TrigIn, TrigOut, DigIn, or InhibitIn.
Specifies the pin polarity.
Sends/reads data from the digital I/O port function
Configures Screen saver, Wake-on I/O, and Display contrast.
Enables/disables key clicks and configures the On/Off key.
Resets all non-volatile RAM settings to their factory defaults.
Displays the Error log.
Enables/disables calibration. You must supply a password to enable.
High Enters measured data for high calibration point.
Low Enters measured data for low calibration point.
Enters measured data.
Calibrates common mode rejection ratio.
High Enters measured data for high calibration point.
Low Enters measured data for low calibration point.
Enters Measured data.
Calibrates the downprogrammer.
Calibrates I peak.
Saves the calibration date for each channel.
Saves the calibration data.
Changes the password.
Displays model, serial number, firmware revision, backup revision,
and active firmware.
Displays model, serial number, options, voltage, current, and power.
Using the Front Panel Menu
33