Dismantling The Slicing Machine - Berkel 330M Owner's/Operator's Manual

ADJUSTING THE CHAIN
If you should hear a ticking noise when using the ma-
chine check the tension of the blade chain as follows:
1.­ Loosen­the­two­nuts­(1)­which­hold­the­head­
(2).
2. Raise­the­head­(2)­until­the­required­tension­
of the chain is obtained.
3. Tighten the nuts and check.
ADJUSTING THE BEVEL GEAR PAIR
If­there­is­too­much­play­in­the­flywheel­at­the­start­of­rotation­proceed­as­follows­to­eliminate­it:
1.­ Remove­the­cover­(1)­using­a­screwdriver.
2. Tighten­the­nut­(2)­until­all­play­is­eliminated.
3. Replace­the­cap­(1).

DISMANTLING THE SLICING MACHINE

The machines are made up of:
• Aluminium alloy structure
• Insertions­and­various­in­stainless­steel
• Electric­parts­and­wires,­etc.
• Electric motor
• Plastic­materials,­etc.
If­disassembly­and­dismantling­are­to­be­carried­out­by­a­third­party,­only­consult­firms­that­are­autho-
rised­in­the­demolition­of­the­above­mentioned­materials.­If­you­carry­out­the­dismantling­yourself­the­
materials­must­be­separated­according­to­type­and­consult­a­specialised­firm­for­their­disposal.­Always­
abide by the regulations in force in your country.
F47008 Rev. A (April 2016)