Table of Contents
Advertisement
Steps to apply the power to the converters are:
1.
Connect power adapter DC plug to the DC input jack located on the back of the converter before
connecting to the AC outlet.
2.
To ensure against accidental disconnection, tie the DC cable with the cable tie located the back of the
converter.
3.
Connect the power adapter to the AC outlet.
4.
Check Power LED indication.
2.4 Making TP Port Connection
TP port is featured to support connection to:
Auto-negotiation devices
Auto-negotiation incapable 10BASE-T devices
Auto-negotiation incapable 100BASE-TX devices
Network Cables
10BASE-T:
100BASE-TX:
Link distance:
Configuration Setup
To make a proper connection, the following configuration settings are recommended:
TP port link partner
Auto-negotiation device
Fixed 10M half duplex device On: forced On: half duplex
Fixed 100M half duplex device On: forced On: half duplex
Fixed 10M full duplex device On: forced Off: full duplex
Rated AC120V/60Hz DC7.5V0.5Amin.
Rated AC230V/50Hz DC7.5V0.5Amin.
Rated AC240V/50Hz DC7.5V0.5Amin.
Rated AC100V/50-60Hz DC7.5V0.5Amin.
Rated AC100V/50-60Hz DC5V1A
2-pair UTP Cat.3, 4, 5, EIA/TIA- 568 100-ohm STP
2-pair UTP Cat.5, EIA/TIA-568 100-ohm STP
Up to 100 meters
SW1
SW2
Off: auto
Off: full duplex
SW3
Off: 100M
On: 10M
Off: 100M
On: 10M
-14-
Advertisement
Table of Contents
