The Back Panel Of The Processor - Cisco Prisma II Installation And Operation Manual

The Back Panel of the Processor

Back Panel Connectors
Self-mating connectors make it easy to install the Prisma II 2:1 Redundant Transmit
Processor in the Prisma II Chassis. The chassis provides:
RF signal input connection
•
Electrical power input connection
•
Alarm communications
•
Status-monitoring communications
•
Communications and control connections
•
Power and Communications Connector
The power and communications connector on the back of the module mates with a
connector inside of the chassis, and supplies power from the chassis to the processor.
The 110-pin connector also routes alarm and status-monitoring information from the
processor to the Prisma II Chassis.
78-715192-01 Rev C Introduction 1-9