Cisco Prisma II Installation And Operation Manual page 31

Connecting Optical Cables,
Cable Connection Procedure
Important: This procedure assumes that the Prisma II 1310 nm bdr Transmitter sub-
module has not been installed in the Prisma II bdr Transmit Processor.
Follow this procedure to make the optical cable connections for each transmitter to
be installed.
Attach one end of the optical cable to the optical output connector located on
1.
the front of the transmitter sub-module.
2. Route the other end of the optical cable to the appropriate destination.
3. Repeat steps 1 and 2 for transmitter sub-module 2.
WARNING:
Avoid damage to your eyes! Do not look into any optical connector while the
system is active. Even if the unit is off, there may still be hazardous optical
levels present.
78-715192-01 Rev C
Continued
Installation 2-11