Starting Lci - Cisco Prisma II Installation And Operation Manual

Starting LCI

Introduction
When you start the LCI software, it queries the devices (modules) located in the
chassis that is connected to your computer. After this query process (referred to as
the learn mode), the LCI software does the following for each device it finds.
• Represents the device in the device tree of the main LCI window
• Makes the polling information available so you can check and configure various
parameters.
Important: Your computer must be connected to the chassis before you start the LCI
software. For instructions, refer to Connecting Your Computer to the Chassis
earlier in this chapter.
Starting the LCI Software
To start the software, perform these steps.
1. Double-click the LCI icon on your Windows desktop.
Result: The LCI Learn Mode Dialog box displays.
2. Verify the communication port displayed in the Port box. This is the port on
your computer that the chassis is connected to.
To change the com port, type the word "com" and then the port number.
Example: To specify com port 2, type COM2.
3. Verify the number displayed in the Chassis ID box. This must be the same
number as is set on the chassis ID wheel on the front of the chassis.
During the query process, this is the first device the LCI software queries.
4-10 Operation Using the LCI Software 78-715192-01 Rev C