Cisco Prisma II Installation And Operation Manual page 28

Installing the Module in the Chassis,
3. Gently slide the processor into the chassis until you feel the power and
communications connections on the back of the processor join connectors on
the backplane. Use the module ejectors on the left side of the module to lock
the module in place.
Note: Do not force or bang the processor into the chassis. If properly aligned,
it should slide in with minimal force.
4. Hand-tighten the screw at the top of the processor to secure it in the chassis.
Use a
2-8
/ -in. flat-blade screwdriver to secure. Do not over tighten.
3
8
Installation
Continued
78-715192-01 Rev C