Cisco Prisma II Installation And Operation Manual page 26

Connecting the RF Cables to the Chassis
RF Cable Connection Procedure
Follow this procedure to make the RF cable connections for the transmit processor.
1. Locate the RF ports of the corresponding slot where the Prisma II bdr
Transmit Processor is to be installed.
2. Attach one 75 ohm RF cable to Port A connector (RF output 1) of the
corresponding slot where the module is to be installed. This is the channel A
RF input connection. See the illustration below.
3. Attach the other 75 ohm RF cable to the Port B connector (RF input 2) of the
corresponding slot where the processor is to be installed. This is the channel B
RF input connection.
4. Route the two RF cables to the appropriate RF sources.
5. If F-connectors are installed, use a 7/16-in. open-end wrench, secure both
cables to the connectors at the chassis.
6. Proceed to the next section, Installing the Module in the Chassis.
2-6 Installation 78-715192-01 Rev C