Divus TOUCHZONE TZ07 User Manual page 26

DIVUS TOUCHZONE .
26
The next entry deals with the network settings of DIVUS TZ:
DIVUS TZ supports the use of a static IP address as well as the usage of DHCP. Depending on your network, these
parameters must be configured correctly in order to connect the DIVUS TZ with your network and also with the
internet (check out the screenshot to the right, which shows the configuration menu for the LAN port). If you are
unsure about the correct configuration, please refer to your network administrator.
NOTE: When the connection has been established correctly, in the upper right corner of this configuration page
a blue symbol showing 2 PCs will be shown. Only when this symbol is active, the DIVUS TZ is correctly connected
to your network. If the symbol is white, no connection is established.
The DIVUS TZ supports also Wi-Fi-based connections. In order to enable this support, you will have to acquire the
DIVUS Wi-Fi stick (not included in the product contents) and connect it to the device. Afterwards you can access
the QuickSettings menu (can be accessed within the DIVUS LAUNCHER settings by swiping downwards, starting
-
the Wi-Fi function, scan for available networks and configure the connection:
NOTE: on successful connection, in the upper right corner of the status bar the typical blue Wi-Fi symbol will be
shown. Only if this icon is shown and blue, the device will be able to communicate through Wi-Fi. DIVUS TZ now
also supports parallel Wi-Fi and LAN connections and offers the default Android settings for the configuration.
The next setting allows changing the hostname of the device, -
up e.g. as the device name when performing a network scan, so changing this name allows for a better
identification of the various devices inside a network. When the hostname is edited, a reboot is required in order
to take over the new value. If an empty string is set as the hostname, then the default value is used.
ATTENTION! This option is available only from image version R2.11 onwards, on previous versions the setting will
either not work or not be available!