Divus TOUCHZONE TZ07 User Manual page 40

DIVUS TOUCHZONE .
40
This lock screen only works as a switch, without showing the actual state of the object. The lock screen can only
perform one action at a time: while mid-action, it will ignore further requests by the user.
NOTE: If at the first start of the native template instead of the desired switch only an empty wall is visualised, this
either means that the is no connection to the specified KNXCONTROL device or KNX bus, or that the configured
-only
mode. In this case, the switch will only be shown if you click once on the empty wall. In order to see also the
correct state of the object, the KNX object must be configured correctly within the OPTIMA interface. Information
on the configuration can be found inside the installation manual of the OPTIMA interface.
The GPIO (general-purpose-input-output) is an additional lock screen, with which the digital output of the DIVUS
TOUCHZONE can be controlled. It is nearly identical to the native KNX lock screen in both function and appearance,
it only has an additional setting to select which output should be controlled.
The option app start allows to select an app and use it as a lock screen. If not already in foreground, the selected
app will start after the set timeout. If the app is already in foreground, then the app itself will remain open. If no
app is selected or the app is no more available, a blank screen is shown.
not possible to set a password.
The option black screen allows to show an empty black screen as lock screen. Further, when using this lock
screen, the display brightness is set to minimum. When the lock screen is closed, the brightness is back to the
previous value.
The next chapter discusses the system settings of the DIVUS TZ.