Divus TOUCHZONE TZ07 User Manual page 37

The web template offers its functionality through a special HTML page which is directly obtained from the
connected KNXCONTROL device. This means that the contents will always be shown in the typical OPTIMA design
and the same page / functions will be available also directly within the OPTIMA interface.
The native template instead offers a completely independent graphical interface, which is highly customizable and
communicates directly with the KNXCONTROL device, without the use of HTML contents. This eliminates the
loading times for the template and permits to use alternative designs.
The GPIO template is similar to the native template, however it allows to directly control the digital output of the
TOUCHZONE.
The following screenshots show an active web template lock screen (on the left side) and the available settings
for its configuration (on the right side), explained below:
-
Lock Screen Timeout:
Defines the time, after which the lock screen should be shown. Please take care that the first access
to the lock screen after changing the template settings always will be take around 40 seconds; the
defined value will then be used for any further start of the lock screen.
-
Lock Screen IP Address:
Defines the IP address of the KNXCONTROL device, which provides the lock screen template
-
Lock Screen ID:
Defines the ID number of the room that is used as lock screen template. This number can be identified
through the search function within the configuration area of OPTIMA. Just search for the desired room;
in the list with the search results the ID number is shown right under the name of the room, as shown
in the following screenshot:
DIVUS TOUCHZONE .
37