Datalogic DS8110 Reference Manual page 74

4
Field Name Action/Definition
2 Inputs
Used
62
Active Level Select Active Open or Active Closed from the
drop-down list to choose the active state of the
input.


Wrong Code Select the check box to enable the transmission
Tx of the Wrong Code (Non-Valid Code).
Wrong String
Select the check box to enable the transmission
Tx
of the Wrong String (Non-Valid String) message.
Wrong String Enter a text string to be sent in case of a
(max. 128 mismatch (wrong code read/non-valid code).
chars)
Beam Shutter Settings
Beam Shutter Select Disabled, Triggered, or Enabled from the
drop-down list. The Beam Shutter turns the laser
off. The Beam Shutter option can be used to
increase the overall laser diode life when used in
high ambient temperature applications (over 35°
C); reduce power consumption; and to turn off the
laser for safety purposes.



The reading phase is defined by 2 inputs. It starts when the Start
Input is activated and stops when the Stop Input is deactivated
(unless the Extended Phase is enabled).
Extended Available only for the On Line/2 Inputs option. If
Phase checked, it allows the Stop Input to end the
reading phase only if the Start Input is also
deactivated.
DS8110 REFERENCE MANUAL
Active Open: The input is active when
there is no current flowing through IN
pins. The input from the verify mode
source is normally closed. The scanner
goes into trigger mode when the input
source is opened.
Active Closed: The input is active when
current flows through IN pins. The input
from the verify mode source is normally
opened. The scanner goes into trigger
mode when the input source is closed.
Disabled: The laser is always on.
Triggered: The laser is turned off as soon
as the code(s) are read or when the
reading phase ends. The laser is turned
on again when the next reading phase
starts.
Enabled: The laser is always off and all
operations are suspended.
Trigger Source