Datalogic DS8110 Reference Manual page 268

7
Error Description Severity
Code
130 Encoder Warning
Timeout
131 Input 1 Error
Failure
132 No Phase Error
Error
133 Input 2 Error
Failure
256
Explanation Symptom
No encoder - The scanner
(tachometer) is may experience
detected in an increase in
specified time. The no-reads.
Encoder signal
provides the - The scanner
scanner with belt may start
speed and other missing the
tracking transmit point.
information.
This error will only
occur when the
scanner is in the
PackTrack mode.
The Primary PS - The scanner will
(photoelectric not go into
sensor) Input is trigger.
stuck in the active
state (PackTrack - No data will be
Mode). transmitted to
the Host.
No Phase
"timeout" is
exceeded (On-Line
and PackTrack
Mode).
- Trigger must be
identified within
a specified time.
Secondary PS - The scanner will
(photoelectric not go into
sensor) Input trigger.
Failure Stuck Active
(PackTrack Mode). - No data will be
transmitted to
the Host.
DS8110 REFERENCE MANUAL
Troubleshooting Action required
- Confirm that the - Adjust the
belt is running. encoder
(tachometer)
- Make sure the mounting.
encoder
(tachometer) - Adjust the
wheel is making Encoder
a firm contact Timeout setting
with the (See section
conveyor. 4.5.9).
- Check the
Global Settings
| Diagnostics |
Encoder
Timeout setting
to confirm that
it is not set too
low (See section
4.5.9).
- Check the - Realign the
alignment of photoelectric
the sensor.
photoelectric
sensor. - Replace the
photoelectric
- Check the sensor.
functionality of
the
photoelectric
sensor.
- Check the - Realign the
alignment of photoelectric
the sensor.
photoelectric
sensor. - Replace the
photoelectric
- Check the sensor.
functionality of
the
photoelectric
sensor.