Oil Seal Replacement (Xr100 Only); Stator Base Installation; Ignition Switch (After 2000) Inspection/Removal/Installation - Honda XR80R Service Manual

OIL SEAL REPLACEMENT
(XR100 ONLY)
Remove the O-ring and oil seal from the stator base.
App ly grease to the new oil seal and a-ring, and
instal l them.
INSTALLATION
XRfOOR:
Install the stator base and tighten tho three screws.
XR80R:
II1$t311 the stator base and t<ght.en the two screws
IGNITION SWITCH (AFTER 2000)
INSPECTION
Oisconn(!ctthe ign ition SWitch connectors .
Chec k to r continuity at the connectors at the ignition
switch side.
There should be no continuity when I he ignition
switch is in the ·ON" position and continuity when
the ign ition SWllch is in the "OFF" position.
REMOVAL / INST ALLATION
Remove the fuel tank ipago
2-31.
Disconnect the ignition switc h connectors .
IGNITION SYSTEM
$'-"71
~1 0\'5'"
O:RING
~
5,\ (
I-; ~
STATOR BASE
C;
@Ji
\ CO N NECTORS
13-13