Table of Contents
Advertisement
9. For a second telephone, plug the telephone cord of a single-line telephone into the Tel 2 port on the
gateway.
10. Check that the LEDs on the front panel cycle through one by one in the following sequence:
LED
POWER
RECEIVE
SEND
ONLINE
LINK
Testing the Connections
Perform the following connectivity test to verify that all the components were connected properly:
1. Power ON the computer and log in.
2. Check that the POWER, RECEIVE, SEND, and LINK front panel LEDs on the gateway are either
solid or blinking. See
Note: The ONLINE LED should turn solid after the gateway is provisioned (activated).
Wall Mounting the Gateway
Before drilling holes in the wall, check the structure for potential damage to
the water, gas, or electrical lines.
You will need a screwdriver and two M3 (#6) screws.
1. Print the
Wall Mounting
Note: You can mount the gateway horizontally or vertically.
2. Remove all cables (power, coaxial, and Ethernet) from the gateway.
3. Choose a location on the wall to mount the gateway.
Notes:
•
Locate the unit according to local or national codes governing residential or business cable TV
and communications services.
•
Follow all local standards for installing a network interface unit/network interface device
(NIU/NID).
SVG1202 Wireless Voice Gateway • User Guide
SVG1202 LED Activity During Startup
DESCRIPTION
Turns solid green when AC power is connected to the gateway.
Indicates power is connected properly.
Blinks while scanning for a downstream (receive) channel.
Turns solid green when the downstream channel is connected.
Blinks while scanning for an upstream (send) channel.
Turns solid green when the upstream channel is connected.
Blinks during gateway registration and configuration.
Turns solid green when the gateway is registered.
Turns solid when an Ethernet connection is made between the
gateway and computer.
Front Panel
for additional status information.
Template.
B
5
Advertisement
Table of Contents
