Testing The Gateway Connections; Setting Up An Internet Connection - Motorola SURFboard SVG6582 User Manual

Installing the Gateway
3. Connect the Ethernet cable to any open Ethernet port on the gateway.
4. Connect the other end of the Ethernet cable to the Ethernet port on your computer.
Repeat steps 3 and 4 for each additional computer or other device.
5. Plug the telephone cord of a single- or two-line telephone into your telephone.
6. Plug the other end of the telephone cord into the TEL 1 port on the gateway.
7. Use the TEL 1 port to connect two-line telephones.
Note: Contact a VoIP service provider to activate this service.
8. For a second telephone, plug the telephone cord of a single-line telephone into the TEL 2 port on the
gateway.
9. Plug the power cord into the Power port on the gateway.
10. Plug the other end of the power cord into an electrical wall outlet. This automatically powers ON the
gateway.

Testing the Gateway Connections

Perform the following gateway connectivity test to verify that all the components were connected
properly:
1. Power ON your computer and then log on.
2. Check that all the LEDs on the front panel of the gateway first FLASH in sequential order and then
light SOLID. See
If an LED did not light SOLID, contact your service provider for assistance.
3. Contact your service provider to activate (provision) the gateway.
Note: Your service provider may allow for automatic activation which will automatically launch a
special website when you open a web browser.
4. Once your gateway is provisioned, open a web browser on your computer, such as Internet Explorer,
Firefox, Google Chrome, or Safari.
5. Type a valid URL (for example, www.motorola.com) in the address bar and then click or press
.
Enter
If the web page did not open, contact your service provider for assistance or proceed to
the Gateway to the Internet

Setting Up an Internet Connection

IMPORTANT! Your computer may already be configured to automatically connect to the
Internet. If so, do not change the network options before contacting your service provider
for assistance.
If you cannot access the Internet after completing the gateway installation, you may have to manually set
up your computer to connect to the Internet. To do this, you will have to enable the network options on
your computer to automatically obtain an IP address and DNS server address.
Please note, operating system-specific commands for configuring computer network options are not
provided in this document.
SVG6x82 Series Wireless Voice Gateway • User Guide
590934-001-a
Front Panel for additional LED status information.
to manually set up the network options on your computer.
B
Connecting
8